HeliSAS helicopter autopilots for your aircraft
The Genesys Aerosystems HeliSAS is a stability augmentation system and two-axis autopilot for helicopters. We quote it for your helicopter from Hangar 202, Lanseria. Pricing is by quote because each HeliSAS kit follows the STC for your helicopter model, and the right kit depends on your avionics.
What it does
HeliSAS is a stability augmentation system and two-axis autopilot. It gives attitude stabilisation and force feedback to the cyclic on helicopters with hydraulically assisted flight controls. The servos connect to the control rods through parallel linkage, so the basic flight control rods stay intact.
Helicopters covered
Bell 206B, Bell 206L, L-1, L-3 and L-4, Bell 407 and Bell 505. Airbus Helicopter EC 120 B (H120), EC 130 B4, EC 130 T2 (H130), AS 350 B, BA, D, B1 and B2, and AS 350 B3 and B3e (H125).
SAS only or full autopilot
Kits are available as SAS and autopilot with beep trim, and as SAS only. We confirm the right configuration for your helicopter and quote it.
Avionics it works with
Heading hold works with a compatible EFIS such as the Garmin G500H or Aspen EFD1000H, or a compatible heading system. VOR, ILS and GPS steering need a compatible receiver and a course display such as the Garmin G500H/TXi, Aspen EFD1000H, Sandel SN3500 or Bendix King KI-525A.
Attitude source
The attitude gyro or digital AHRS is bought separately, and a digital attitude source is recommended. Each STC lists the avionics combinations it is approved for, so we check yours before we quote.
Request a quote
Tell us about your helicopter and the avionics in it and we will confirm what applies and send you a quote.